Dillon Powder Through Die Adapter
MK Machining is now offering a Dillon Powder Through Die Adapter that allows our antistatic funnels to be used with Dillon 450, 550, and 650 presses.
This funnel adapter was designed and tested with the Dillon Standard Powder Measure Die (P/N: 20064)
Note that this will not work with the Dillon 1050 due to primer tube interference with our antistatic funnel. Custom 1050 funnel possible if there is consumer interest.
Cory Thomes (verified owner) –
Good quality printed part. If I could make one improvement it would be either a little tighter fit for stability or print in a little beveled ring halfway up on the inside to catch the locking notch that dillon has on there powder die so it slightly presses on and clips in place. Other thanks that works great for when I want to quickly and confidently load different grains per case.
Seth D –
Great purchase. I was slightly worried about the fit based on Cory’s review. However, I found that to be a non-factor. The fit isn’t snug, but loose. Which is how I wanted it to fit. You can tap aggressively on the funnel and it will not come off of the die. I look forward to using this!
Mike Noonan (verified owner) –
Great product. Works well. The problem people are having is that this is designed to go on the AT 500 powder die, not the stock powder drop that is for the powder drop. It’s wobbly and loose on the powder drop through die. Fits perfect and snug on the AT 500 . Would recommend and buy again.