Tangent Theta Scope Caps

MK Machining is excited to offer Tangent Theta Scope Caps. Our scope caps are made out of a Nylon 11 material using an HP MJF 5200 3D Printer. Nylon 11 is slightly flexible to fit over your scope objective without becoming brittle and is strong enough to handle wear and tear. Scope caps feature a custom made spring for full range opening and closing of the cap without unnecessary noise. Caps slip over the objective and are tightened down using a single bolt. Compatible with MK Machining ARDs

 

This Objective Cap has been tested to work with following  Tangent Theta scopes:

Tangent Theta Marksmen 3-15×50
Tangent Theta 3-15X50
Tangent Theta 5-25×56

 

These scope caps will only fit the listed Tangent Theta scopes. If you are unsure of which one to order contact [email protected] for assistance.