Description
AutoTrickler V4 Accessories Bundle (Funnel + Overserts 3-Pack)
One kit to tune your V4, control the finish, and reduce the little frustrations that slow you down
The AutoTrickler V4 Accessories Bundle combines three V4-focused upgrades into one package for reloaders who want a more repeatable setup, more controlled finishing behavior, and cleaner powder changes. Instead of piecing together separate parts later, this bundle covers the main areas where small improvements make a big difference in day-to-day use: rear angle tuning, finish-stage kernel control, and better powder drop behavior when using an aftermarket cup.
What’s in the bundle
- Shim & Hopper Base System: upper base, lower base, 7 labeled shims (3.0mm–6.0mm in 0.5mm increments)
- AT V4 Funnel: replacement funnel designed for customers using the Area419 aftermarket powder cup
- AT V4 Overserts (3-pack): #10, #12, #18
How it helps
- Rear angle tuning (shims): Rear shimming can improve dispensing reliability; proper shimming helps keep the small tube “finish speed” consistent enough to drop individual kernels at the target weight and help reduce overthrows.
- Cleaner powder changes (hopper base): Designed to address powder getting trapped at the acrylic cylinder/base interface, with built-in storage for shims not in use.
- Finish-stage control (overserts): Internal threads are designed to line powder up in a “single file,” making it easier to drop a single kernel when finishing for a more accurate charge.
- Reduced bounce potential (funnel): Taller design hovers closer to the cup to reduce drop height, with an offset straw to guide powder down the cup wall rather than dropping into the center.
Compatibility & installation notes
- Compatible with: AutoTrickler V4
- Funnel intent: designed for customers using the Area419 aftermarket powder cup
- Hardware included: none (hopper base installs with factory hardware)
- Shim install note: remove the clear “cabinet bumper” from the rear of the dispenser; shims are designed to fit into that cavity
AutoTrickler V4 Overserts installation instructions:
Learn more about Why Your AutoTrickler V4 Changes Behavior Between Powders
Kendrick Inman (verified owner) –
I ran 100 rounds through my AutoTrickler V4 and had 34 charges being 0.04g or more (some 0.14) over my set charge weight.
After installing the AutoTrickler V4 Accessory bundle and tuning my AutoTrickler V4 I loaded another 100 rounds. I had 2 overthrows of 0.04g over my desired charge weight. Talk about making a difference.
On another note, I only had two kernels of powder that bounced out of my Area 419 powder cup, that is also a tremendous improvement over the factory powder funnel.