MK Machining Scope Caps
MK Machining is excited to offer our MK Machining Scope Caps. Scope caps are made out of a Nylon 11 material using an HP MJF 5200 3D Printer. Nylon 11 is slightly flexible to fit over your scope objective without becoming brittlem and is strong enough to handle wear and tear. Scope caps feature a custom made spring for full range opening and closing of the cap without unnecessary noise. Caps are a press fit over the objective and are tightened down using a single bolt. Compatible with MK Machining ARDs. Â The tolerance on our caps allows for an objective that is approximately .005″ smaller than the listed diameter. If your diameter is larger than the scope cap size it will not fit. If you have questions please email us at [email protected] for assistance.
Â
Looking for Scope Cap Sets by Brand? Click Here
John –
“Satisfied” would be an understatement. After a long time spent looking for some quality scope caps… and after more than a couple alternatives that I ended up sending back (either due to lack of quality control or a loose fit), I decided to try MKM. If you’re in the same boat — STOP LOOKING and buy these. And if you need a custom size, don’t hesitate to email them. You won’t regret it. Tight, perfect fit. Stellar quality. And best of all, made in the U.S.A. You can finally put those Butler Creek caps in the trash where they belong.